Towing

The BOLT Series lets you customize as many locks as you want to work with ONE key – YOUR TRUCK KEY.

The holy grail of suspension technology is the perfect blend of ride comfort and load hauling capacity. In the past, auto builders had to choose one over the other. Today, with the Air Lift Air Bag Suspension Kit, you get the best of both worlds-a smooth ride and plenty of backbone to haul the heaviest loads. The secret behind the Air Lift Air Bag Suspension Kit is simple: you control the firmness of the air bags. When you re fully loaded or towing a trailer, fill them full of air to do away with sag, sway, bottoming out, roll and more. For everyday commuting, keep them deflated for a downy soft ride. Dragsters can also use the Air Lift Leveling System for greater rear-wheel traction at the speedway. With an Air Lift On Board Air Control System, you can even make on-the-fly adjustments as road conditions change.

Custom Hitch Covers

Tanks come with a 2″ female pipe thread coupling for manual or 12V transfer pump (not included) No-Rust Aluminum Tank can be used to transport diesel, gasoline, or aviation fuel DOT Approved Tank with 1/8” heavy-duty aluminum construction Fully welded seams 100% pressure tested 3/16” heavy duty aluminum mounting brackets Built-in baffles reduce sloshing Locking gas cap Rollover valve (pressure relief vent) Includes 3/8” FTP drain plug Diesel install kits are available for diesel gravity feed (sold separately)

The DV8 FBTT2-03 is designed to protect your 07-13 Toyota Tundra, it features recovery shackles and can accommodate up to a 12,500 lbs winch. The bumper flows with the body lines of the Tundra perfectly and adds protection to your front end. It is made out of 3/16 inch cold rolled steel with ¼ inch reinforcement where necessary and has aluminum mesh to allow cold air to permeate the bumper and flow properly to your trucks OEM components.

DV8 truck bumpers are a modular 3-piece design made with high tensile strength 3/16" steel and reinforced with 1/4" steel in key areas which allows them to accommodate up to a 12,500 lbs winch. We also use a 2 step powder coating process. First the bumper is coated with a thick layer of a proprietary compound for corrosion resistance, then we coat the bumper with our textured black, UV resistant, scratch resistant powder coating. The result is a bumper that will look good and perform well for the lifetime of the vehicle.